Enabling/Disabling With The Keypad Or Remote Control - HomeSecure HS-PRO-01 User Manual

7.2 Arm/Disarm with Keypad or Remote Control
The alarm system can be armed, disarmed, arm stayed and panic triggered on the keypad or remote
control.
Note! You can only use the master code, user codes and temporary code to
arm and disarm the alarm system. The Installation code can only be used to
program the alarm system.
7.2.1 Arm away
From the main screen, press [Arm away] on the
alarm panel keypad or on the remote control
( ). Status LED will change from green to
red while the voice guide says, "Arm away,
close door and window, exit delay starts".
When exit delay ends, the voice guide will
say, "Armed away!" LCD display shows the
following:
7.2.2 Arm stay
Sensors in the active zone will not trigger alarm during [Arm stay], but
sensors in all other zones will trigger alarm.
If you press the [Arm stay] button on the keypad or the remote control
( )while the alarm system is disarmed, the Status LED will change from
green to red. Voice guide will say, "Arm stay", and the LCD displayed shows:
7.2.3 Disarm
Press the disarm button (
control to disarm directly.
Press disarm on the keypad and the voice guide
says "Enter password, add 0 to delete the
event log!" Input the access code (not
installation code) and end with [0] and [#] to
delete the alarm log. Arm LED changes from
red to green and the voice guide says, "Disarmed, alarm log eliminated!"
The even will be saved in the event log if you DO NOT press [0] after the code (ie. only [#]).
) on the remote
Copyright © 2015 HomeSecure
HomeSecure HS-PRO-01 Manual: 22-08-2014
26