HomeSecure HS-PRO-01 User Manual page 12

Motion Detector:
Insert all batteries and put the sensor back in the box. Wait 10-15 minutes and take the sensor out of
the box to trigger and register.
Note, the motion detector has a so-called detection interval of 5 minutes, read more about it in [5.5
Install Motion Detector].
If you try to register a sensor that is already registered, the voice guide will
indicate it is already registered. If the signal is in a wrong format, the voice
guide will say "Wireless Transmission Received".
If no signal is received within the 60 seconds, the voice guide will
say "Enrolling Failed".
You must register each sensor in order for the alarm panel to recognize the wireless signal. Each sensor
has a unique encrypted ID code, which the alarm panel can only recognize once the sensor is registered.
Remember to set Zone Type for each sensor right after registering them. See
[4.3 Zone Types] on the next page.
HomeSecure HS-PRO-01 Manual: 22-08-2014
Copyright © 2015 HomeSecure
12