Start Up And Registration Of Sensors; Start Up; Menu Operation - HomeSecure HS-PRO-01 User Manual

Start up and Register Devices

4.1 Start Up

After connecting power supply and backup battery, the alarm panel will automatically turn on. The siren
will beep and the voice guide says: "Welcome to intelligent alarm system". First you must set date and
time:
The alarm system will keep track of time as long as it is connected to a power supply. If power is
disconnected, the clock will reset and has to be set again. See below:
The icon will move to next input automatically after each input. When you
are finished, press [#] to confirm. If you press [*] during setting, "invalid
set" will appear on the screen. Press [*] to try again.
You now arrive at the alarm system's main screen:
From this screen you can access the programming menu:
Use the installation code to access the programming menu. It is 1234 as standard. We highly
recommend that you change all codes after setup.
1. While the alarm is disarmed, press the menu button on the panel
2. The voice guide will say "Enter password before setting the parameters". Input the installation code
and finish with [#]. If the alarm says "wrong password", press the open pad lock and input code 0808
and start again from 1.
3.
Now you are in the installation menu where all settings are made.
Arrows [6] and [9] navigates up and down, [#] means confirm/enter and [*] mean cancel/go back.
HomeSecure HS-PRO-01 Manual: 22-08-2014

Menu Operation

Copyright © 2015 HomeSecure
.
10