Walk Test - HomeSecure HS-PRO-01 User Manual

The motion detector should be installed at 1.8 to 2.2 meters height and point slightly downwards. Pet
immune sensors should be installed at 1.8 meters height.
Use the 5MIN detection interval described on the last page to save battery. If
the sensor detects movement, it takes 5 minutes before it can detect
movement again. Use TEST instead to have it detect continuously but note the
extra battery use.

5.6 Walk Test

The last test we recommend that you carary out is the walk test. This test will ensure that all sensors are
working properly. Make this test right after installing all devices and also with regular intervals after
installation. At all registered sensors are shown. Trigger them one by one (remember the 5 minutes
interval on the motion detectors). When the alarm panel receives the signal from a sensor, the sensor
will be removed from the list.
When the list is cleared and it says "No Device!", the test has been completed and the alarm system is
functioning properly.
The walk test will run for 10 minutes max. Press [*] to finish the test.
HomeSecure HS-PRO-01 Manual: 22-08-2014
Copyright © 2015 HomeSecure
19