Event Log; Operation Using Call - HomeSecure HS-PRO-01 User Manual

7.6 Event Log

The alarm system saves the latest 255 events in the event log. Events refers to alarm events but also all
operation of the alarm panel. When the event log is full, it will start deleting from the oldest events.
Follow below procedure to access the event log. Press
examples are for fire alarm and disarm of the alarm system.
7.7 Operation via Call
Call operation enables you to remote control the alarm system by calling it. Simply call the phone
number of the SIM card in the alarm panel. You will then be asked to input code (master code or one of
the four user codes) followed by #. The voice guide will then prompt you to: "For arm-away, press 1, for
arm-stay, press 2, for disarm, press 3. For alarm repeat, press 5, turn-on site siren, press 6, turn-off site
siren, press 7, for hang up, please press 0".
If you type on the phone or the alarm panel during playback, there might
occur communication error. We recommend that you wait until playback has
finished before you type.
Call operation is only possible while the alarm panel is in standby mode.
HomeSecure HS-PRO-01 Manual: 22-08-2014
/
Event Log: Event order
Zone: Zone number and name on the zone
that has triggered alarm
Type: Zone type on the sensor.
Time: Time of the event
Event Log: Even order
User: User type and name
Type: Event type (arm/disarm/enter
menu/exit menu/etc.)
Time: Time of the event
Copyright © 2015 HomeSecure
to navigate between events. Below
Explanation
30