Panasonic S-22KA1E5S Service Manual page 164

Left feeding-out
position
Remote control
cable
Rear feeding-out
position (when
cable is to be
embedded)
•
If controlling using two remote controls, refer to
the "Control using two remote controls" under
section "4. Settings."
•
Secure the upper case to the lower case.
(Hook the upper tab of the upper case into the
lower case, and then push the upper case until it
snaps shut onto the lower case tab, while being
careful not to clamp the remote control cable and
the connector cord.)
If remote control cable is embedded
1. Embed an outlet box into the wall, and then secure the remote control base plate to the outlet box with the two
accessory M4 screws. Make sure that the base plate is flat against the wall at this time, with no bending
(looseness)
2. Pass the remote control cable into the box and then install the remote control.
Remote controller
Connector CN1
Remote controller
Top feeding-out position
Lower case
Wall
Terminal block
upper case
Upper tab
lower case
M4 screw
(accessory)
Lower tab
Connector cord
Right
feeding-
out
position
Tab
Setting switch
Lower case
Medium-sized square outlet box
Remote
(obtain locally)
control cable
164
Upper case
Notches
Connector
CN1
MASTER
SLAVE
Ventilation holes
Temperature sensor
Upper
case