Jumper And Connectors - Advantech FWA-3232 Startup Manual

Installation
Connection for DC power source
Attention:
Only trained service personnel are authorized to install and
remove the -36- -60 volt DC power supply ,and make the
connections to and disconnections from the -36- -60 volt DC
power source. The customer is responsible for ensuring that
only trained service personnel are authorized to install and
remove the -36- -60 volt DC power cable.
To Connect Power supply:
The DC supply source for the equipment power supplied shall
be an UL certified power source and suitable for specification
provided by the manufacturer. Please use the jacketed power
cable with 16AWG or 11Amp, 60 volt to connect between the
equipment and the DC power source.
1. Turn off DC power source and equipment that is to be
connected this product.
2. Ensure DC power source connected earthed cable.
3. Connect the earthed cable which is of AWG16 min. green
and yellow wire of earth of building to the protective
earthed terminal of the equipment.
4. Connect power cables to the power source.
5. Ensure correct polarity.
6. Turn on the power source.
To Disconnect Power supply:
1. Turn off DC power source and equipment.
2. Disconnect the power cord from equipment.
3. Remove the earthed cable from protective earthed
terminal of the equipment.
For YH-5301K
RTN is +, -36- -60VDC is –
For DM1Y2-5300V2H

Jumper and Connectors

The board has a number of jumpers that allow you to configure
your system to suit your application. The table below lists the
function of each of the jumpers and connectors.
Jumper
Pin Default Setting
Name
1-2 Jumper short
JCMOS1
2-3 Open
Jumper short
8051_JTAG1 3-5
Open
8051_JTAG2
Jumper short
8051_JTAG3
3-5
8051_JTAG4
Open
1-2 short
BPLED1_2
BPLED3_4
BPLED5_6
2-3 short
1-2 Jumper short
PSON1
2-3 Jumper short
1-2 Jumper short
JVGPIO1
2-3 Jumper short
JC8051_12 1-2 Jumper short
JC8051_34
2-3 Open
JC8051_56
Function
Normal status
Clear CMOS
Disable stand bypass
Enable stand bypass
Disable Adv bypass
Enable adv bypass
Bypass LED indication
by LAN LED
Bypass LED indication
by LED cable
AT mode
ATX mode
5V power for GPIO
3.3V power for GPIO
Adv bypass
NC