How To Use Global Options; Fc Info; Address - Hunter Genesis Programming And Operations Manual

HOW TO USE GLOBAL OPTIONS

Global Options are not linked to any Program or Program/Start, and they affect all operations of the controller.
The Global Options are:
#1 FC Info (billboard)

#2 Address

#3 MR Runtimes (Radio units only)
#4 MR Pump (Radio Units only)
#5 Xmit test (Radio Units only)
#6 Default Programs
TO SET A GLOBAL OPTION
Press the OPTIONS key, with current time in the display.
To select a specific option, you may immediately press the number key for that option, then ENTER,
Continue pressing OPTIONS until the correct option title shows in the display- then press ENTER.
TO SET THE OPTION
After you select the option, follow the steps for setting that option:
Option #1

FC Info

This option starts the billboard display which shows relevant information about the configuration of your field
controller. You cannot change anything from this option field- it is strictly for information. After the billboard
information has cycled, the display will return to the FC Info option display.
If this is the first time you have applied power to a field controller, or if the controller has experienced a recent
power outage, the display will alternate between the Time and POWER OUTAGE. Press CLEAR to remove the
POWER OUTAGE message.
Option #2 Address
This option allows a unique address to be set in a Genesis field controller so that it may be individually identified
by the central interface.
When you select Option #2 on a Genesis Field Controller, the display shows:
Address < x>
On a Genesis stand-alone or Modular Field Controller, the Address is not used.
Press the number key or keys for the address number you want to assign to the field controller. Valid
entries are 0-999. In this example, the address is being set to 5:
Accepts the address setting, and the display shows:
18
- or -
(x = address set, 0 = default)
Address 5
Address= 5
GENESIS OPERATIONS MANUAL