Cluster On Times - Hunter Genesis Programming And Operations Manual

TO SET THE OPTION
After you select a Program (and a Start, if necessary) and an option, follow the steps for setting that option:
Option #1 - Cluster On Times
With this option, you can set a group or range of stations to run the same length of time. For example, you can set
stations #2 through #5 to run ten minutes each.
Select the Program and Start you want to set Run Times for. Then, when you select option #1, the display shows:
Begins the process of setting this option. The display changes to:
Press number key(s) for the Run Time you want to set for a group of stations. This
example shows ten minutes:
Note: The time mode (M or S) is dependent on the setting of Option #7. If you want to change modes, see Option
#7.
Sets the length of the Run Times in this group of stations. The display shows:
Completes your selection of the first station. In this example, the display shows:
Note: If you press ENTER instead of entering a number, the setting will include all stations from the first in the
group to the highest station number in the controller.
Completes the option setting. The display shows:
Exits the function, restores the time display.
Press the number key for the first station in the group. If you press ENTER instead of
entering a number, the display shows 1.
From 2 To xx (xx = highest station #in the controller)
Press the number key for the last station in the group. In this example, the display shows:

Cluster On Times

RunTime? <off>
Run Time 0:10M
From -- To --
From 02 To 05
DONE!
GENESIS OPERATIONS MANUAL
21