Options For Running Your Irrigation System - Hunter PRO-C P2C Series Owner's Manual And Installation Instructions

Run
After programming is complete, turn the dial to the RUN
position to enable automatic execution of all selected
programs and start times.
System Off
Valves currently watering will shut off after the dial is turned
to the SYSTEM OFF position for two seconds. All active
programs will be discontinued and watering will stop. To
return the controller to normal automatic operation, simply
return the dial to the RUN position.
Manually Run a Single Station
1. Turn the dial to the MANUAL position.
2. Station run time will flash in the display. Use the →
button to move to the desired station. You may then use
the + and - buttons to select the amount of time for a
station to water.
3. Turn the dial to the RUN position to run the station.
(Only the designated station will water, then the
controller will return to automatic mode with no change
in the previously set program.)
Note
The Manual single station function ignores any
attached sensor and will allow watering to occur.
Built on Innovation
®

Options for Running Your Irrigation System

Seasonal Adjustment
Seasonal Adjust is used to make global run time changes
without reprogramming the entire controller.
1. Turn the dial to the SEASONAL ADJUST position.
2. Press the + or - buttons to set the percentage desired
from 5% to 300%.
To view the new adjusted run time, turn the dial to set the
run time. The displayed run time will be updated accordingly
as the seasonal adjustment is made.
Note
The controller should always be initially programmed
in the 100% position.
21