Section 7: Finishing The Fireplace - Montigo DL6315 Installation & Maintenance Manual

Section 7: Finishing the fireplace

Install the supplied non-combustible cement board to overlap the
new horizontal & vertical 2 x 4's, place the non-combustible wall board
above the fireplace throat, allowing 1/8" clearance from the rim above
the fireplace opening. Pre-drill the board with 1/8" drill bit and secure
to framing with nails, use flat heat sheet metal screws to fasten the
board to the metal header.
SINGLE SIDED
Top (Qty 1)
Sides (Qty 2)
Bottom (Qty 1)
Cut standard Gyproc / Drywall board to complete the installation of
the surround. Fit the edge of the board to the rim around the fireplace
opening. Fasten the board in place using standard drywall screws.
206
A
1
8 8 "
Figure 28. supplied non-combustible cement board dimentions
D6315, DL6315
A 8 ⅛''
B 66 ⅛''
C 24 ⅝''
D 16 ½''
E 13''
F 54 ⅛''
48
SEE-THRU
Top (Qty 2)
Sides (Qty 4)
Bottom (Qty 2)
1680
B
1
66 8 "
625
C
5
24 8 "
419 D
1
16 2 "
E
330
13"
206
A
1
8 8 "
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF CANADIAN HEATING PRODUCTS. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF CANADIAN HEATING PRODUCTS IS PROHIBITED.
1375
F
1
54 8 "
REV. DESCRIPTION
- .
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF CANADIAN HEATING PRODUCTS. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF CANADIAN HEATING PRODUCTS IS PROHIBITED.
Installation
Figure 28.b non-combustible cement board with framing
DIMENSIONS ARE IN INCHES
TOLERANCES:
FRACTIONAL 1/32"
TWO PLACE DECIMAL
THREE PLACE DECIMAL
ANGULAR .5
ALL BENDS ARE ASSUMED
TO BE 90 UNLESS NOTED
OTHERWISE.
Figure 28.c non-combustible cement board with framing
DIMENSIONS ARE IN INCHES
TOLERANCES:
REVISIONS
FRACTIONAL 1/32"
TWO PLACE DECIMAL
DATE CHANGED BY THREE PLACE DECIMAL
ANGULAR .5
ALL BENDS ARE ASSUMED
- -
TO BE 90 UNLESS NOTED
OTHERWISE.
NAME DATE Description
Framing Assembly 3
DM 12/12/2016
Drawn by
.015"
DWG. NO. DL63-Framing Assembly 3
Revision / Date A
.005"
Revision
MATERIAL
Finish
SCALE 1:32 WEIGHT: SHEET 1 OF 2
NAME DATE Description
Framing Assembly 3
DM 12/12/2016
Drawn by
.015"
DWG. NO. DL63-Framing Assembly3
A
.005" Revision / Date
Revision
MATERIAL
Finish
SHEET 2 OF 2
SCALE 1:32 WEIGHT:
XG0221