Control Board upgrade/replace
Adding options to DL units
requires control board
upgrades for the following
options
Fan Kit DFK-3
LED Kit MCLEDDL63
Remote Control
Stepper Motor
Powervents
1. Remove existing basic board drawer by unplugging all existing
connections.
Figure 24. Remove existing basic board
2. Unplug PPO from board located underneath the pilot
assembly. Disconnect the ground and remove drawer
completely.
Figure 24.b Remove existing basic board
3. Discard old drawer and wall switch and valve wires.
40
When upgrading the
Distinction control board,
the board will be shipped
with the board installed in
the drawer and with the
appropriate cables installed.
4. New Board.
Fans
Figure 24.c Proflame2 Board
D6315 (ST) (N/L) I-2 Wiring Diagram
Figure 24.d D6315 (ST) (N/L) I-2 Wiring Diagram
Installation
Pilot
On/Off
Switch
LED
PPO &
Ground
XG0221