Removing And Replacing The A25-A28 Receiver Couplers And Mounting Brackets - Keysight Technologies N5221A Service Manual

Repair and Replacement Procedures
Removing and Replacing the A25–A28 Receiver Couplers and Mounting Brackets
Removing and Replacing the A25–A28 Receiver Couplers and
Mounting Brackets
Tools Required
— T-6 TORX driver (torque to 4 in-lb or 0.45 N.m)
— T-10 TORX driver (torque to 9 in-lb or 1.02 N.m)
— 5/16 inch open-end torque wrench (torque to 10 in-lb or 1.13 N.m)
— ESD grounding wrist strap
Removal Procedure
Refer to
Be careful not to damage the center pins of the semirigid cables. Some
flexing of the cables is necessary to remove assemblies but do not
over-bend them.
1. Disconnect the power cord.
2. Remove the outer cover. Refer to
3. Position the analyzer bottom side up.
4. Disconnect three semirigid cables (item
5. Remove two screws (item
6. Move the disconnected semirigid cables out of the way and lift the
7. Remove two screws that attach the receiver coupler to be replaced to the
Replacement Procedure
1. Reverse the order of the removal procedure.
2. Perform the post-repair adjustments, verifications, and performance tests
Keysight N5221A/22A Service Guide
Figure 7-17 for this procedure.
replaced.
coupler to be replaced.
receiver coupler mounting bracket, with the receiver coupler attached, out
of the analyzer. It may be necessary to loosen the connector at the other
end of some of the semirigid cables to allow them to be moved enough.
receiver coupler mounting bracket, and remove the receiver coupler from
the bracket.
Torque all RF connectors to 10 in-lbs.
that pertain to this removal procedure. Refer to
"Removing the Covers" on page
①
) from the receiver coupler to be
➁
) from the mounting bracket of the receiver
Table 7-2 on page
7-6.
7-60.
7-39