Install A Hot-Swap Drive - Lenovo ThinkSystem ST550 7X09 Maintenance Manual

Step 2. Grasp the tray handle and carefully slide the drive out of the drive bay.
Figure 69. Hot-swap drive removal
After removing a hot-swap drive:
1. Install a new drive or install the drive filler to cover the drive bay. See "Install a hot-swap drive" on page
96.
Attention: To ensure that there is adequate system cooling, do not operate the server for more than two
minutes without either a drive or a drive filler installed in each bay.
2. If you are instructed to return the old hot-swap drive, follow all packaging instructions and use any
packaging materials that are provided.

Install a hot-swap drive

Use this information to install a hot-swap drive.
"Read the
installation
Guidelines" on
page 59
The following notes describe the type of drives that your server supports and other information that you must
consider when you install a drive.
• Depending on your server models, your server supports the following drive types:
– NVMe SSD
– SAS/SATA SSD
– SAS/SATA HDD
For a complete list of supported optional devices for the server, see:
http://www.lenovo.com/us/en/serverproven/
96
ThinkSystem ST550 Maintenance Manual
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 60