Before removing the front bezel:
1. If the server is installed in a rack, remove the server from the rack. Then, remove the rack latches. See
"Remove a rack latch" on page 65.
2. If your server has the front door installed, remove the front door. See "Remove the front door" on page
61.
3. Remove the server cover. See "Remove the server cover" on page 68.
To remove the front bezel, complete the following step:
Watch the procedure. A video of the removal process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Acsjj4tU79GzKnWG316BYn
• Youku:
http://list.youku.com/albumlist/show/id_50483452
Figure 51. Front bezel removal
Step 1.
Pivot the two plastic tabs outward until you can remove the front bezel completely.
Install the front bezel
Use this information to install the front bezel.
"Read the
installation
Guidelines" on
page 59
To install the front bezel, complete the following step:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-Acsjj4tU79GzKnWG316BYn
• Youku:
http://list.youku.com/albumlist/show/id_50483452
82
ThinkSystem ST550 Maintenance Manual
"Power off
the server
for this task"
on page 12