Lenovo ThinkSystem ST550 7X09 Maintenance Manual page 182

Lenovo XClarity Essentials OneCLI sets the DMI in the Lenovo XClarity Controller. Select one of the following
methods to access the Lenovo XClarity Controller and set the DMI:
• Online from the target system, such as LAN or keyboard console style (KCS) access
• Remote access to the target system (LAN based)
Step 1. After you haveLenovo XClarity Essentials OneCLI in place, type the following commands to set the
DMI:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model> [access_method]
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n> [access_method]
onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag> [access_method]
Where:
<m/t_model>
The solution machine type and model number. Type mtm xxxxyyy, where xxxx is the machine
type and yyy is the solution model number.
<s/n>
The serial number on the solution. Type sn zzzzzzz, where zzzzzzz is the serial number.
<asset_method>
The solution asset tag number. Type asset aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa, where
aaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaaa is the asset tag number.
[access_method]
The access method that you select to use from the following methods:
• Online authenticated LAN access, type the command:
[−−imm xcc_user_id:xcc_password@xcc_internal_ip]
or
[−−bmc xcc_user_id:xcc_password@xcc_internal_ip]
Where:
xcc_internal_ip
The BMC/IMM/XCC internal LAN/USB IP address. The default value is 169.254.95.118.
xcc_user_id
The BMC/IMM/XCC account name (1 of 12 accounts). The default value is USERID.
xcc_password
The BMC/IMM/XCC account password (1 of 12 accounts). The default value is
PASSW0RD (with a zero 0 not an O).
Notes:
1. BMC, IMM, or XCC internal LAN/USB IP address, account name, and password are all
valid for this command.
2. If you do not specify any of these parameters, OneCLI will use the default values. When
the default values are used and OneCLI is unable to access the Lenovo XClarity
Controller using the online authenticated LAN access method, OneCLI will
automatically use the unauthenticated KCS access method.
Examples that do use the user ID and password default values:
onecli config set SYSTEM_PROD_DATA.SysInfoProdName <m/t_model>
onecli config set SYSTEM_PROD_DATA.SysInfoSerialNum <s/n>
onecli config set SYSTEM_PROD_DATA.SysEncloseAssetTag <asset_tag>
174
ThinkSystem ST550 Maintenance Manual