Table of Contents
Advertisement
6.
Use the LCD menu system to start the cleaning cycle.
a.
Begin when the printer displays Ready and the U
button shows steady green. Press the U
Suspended displays on line 1 of the LCD panel.
b.
Press E
c.
Maintenance displays on line 2 of the LCD panel. Press
E
to enter the Maintenance menu.
NTER
d.
Cleaning Card displays on line 2 of the LCD panel. Press
E
to enter the Cleaning Card menu.
NTER
e.
Start displays on line 2 of the LCD panel. Press E
start the cleaning process.
f.
Insert cleaning card displays on the LCD panel. Press the
U
button to start the cleaning cycle.
SER
The printer moves the card through the printer several
times. If the vertical option is installed, the card moves
into the vertical area and cleans the rollers located there.
At the end of the cleaning cycle, the cleaning card stops as it is entering the printer reject
tray (RT1).
7.
Open the printer access door and remove the used cleaning card.
8.
Continue with
CR825 and CE875 Instant Issuance System Installation and Administrator's Guide
to enter the menu system.
NTER
If you are cleaning a system with an embosser, the cleaning card enters the
embosser and stops on top of the emboss wheel. Open the embosser access
door to remove the cleaning card from the system. You can remove the indent
cartridge to access the card, if necessary.
"Install Supplies"
on
SER
button.
SER
to
NTER
page
22.
21
Advertisement
Table of Contents
