Appendix A: Ce875 Instant Issuance System; Introduction - DataCard CR825 Installation And Administrator's Manual

Appendix A: CE875 Instant
Issuance System
This appendix provides information about setting up the CE875 instant
issuance system.

Introduction

The CE875 system consists of a card printer and the CEM embosser. The CE875 system can print
cards and then emboss and indent characters on the card. The embosser creates the raised
lettering and numbering on the front and back of most financial or debit cards.
The embosser can contain an embossing wheel and topping and indent ribbon cartridges. The
embossing wheel can have up to 75 punch and die (emboss) or punch and anvil (indent) pairs. A
second wheel option allows for up to 75 additional emboss characters. Multiple font choices and
a variety of special characters are available for the embossing wheel.
Single-Hopper System
CR825 and CE875 Instant Issuance System Installation and Administrator's Guide
Printer
Embosser
Multi-Hopper System
Multi-Hopper
A-1