1080 I/P Mode; Cautions On Connection - Toshiba IK-4KE Instruction Manual

Camera control unit
Table of Contents

Advertisement

5. 1. 2 In case output mode is 1080p or 1080i
Lens
(commercial
product)
Camera Cable
for IK-4KE
Camera
Head
IK-4KH
(option)
* 3G/HD-SDI A, B, C, D terminals output the same signal.

5. 2 Cautions on Connection

• When connecting the camera cables, be sure to turn off the camera control unit and any other equipment
connected to it.
• For DC power supply connecting to DC IN 12V terminal, use class II DC power supply approved according
to EN60950-1 in Europe. or use UL listed and/or CSA approved ungrounded type AC adaptor with the
specifications described below in U.S.A. or Canada.
Power supply voltage : 12V DC ±10%
Current rating
Ripple voltage
Connector
• If the securing screw on the connector of the camera cable loosens, noise may appear on the screen. Be sure
to tighten the connector completely.
• Only use the specific optional camera heads with this camera controller.
The use of any other camera heads may cause damage to the control unit and camera head.
• The video signal output of this camera control unit has no function for automatically selecting output according
to the monitor TV. Therefore, be sure to switch the output mode of this camera control unit according to the
monitor as no image will be displayed on the monitor if the camera output mode and the monitor input mode
do not match. For switching, refer to the item 6.6 "Switching of Video Signal Output".
• SDI interface
The SDI (serial digital interface) is a high-speed serial interface standard used mainly in commercial video
equipment. This unit supports both HD-SDI and 3G-SDI.
When image output is "4K" or "1080p", 3G-SDI output is used. When image output is "1080i", HD-SDI output
is used.
Use a 3G/HD-SDI compatible cable to connect to the 3G/HD-SDI terminal.
Note:
The image may not appear on the monitor's screen immediately, depending on the conditions and the type of
monitor.
IK-4KE
Camera
Control unit
(option)
: More than 1.5A
: Less than 50 mV (p–p)
: HR10A–7P–4S by HIROSE electronics Co. Ltd
Pins 1, 2 : +12V
Pins 3, 4 : GND
3G/HD-SDI
DC IN 12V
DC power supply
(option)
11
Coaxial cable, 75
(commercial
product)
SDI monitor
3G/HD-SDI TV
(commercial product)

Advertisement

Table of Contents
loading

Table of Contents