Table of Contents
Advertisement
Table -2:
Danger and warning information
Danger and warning information
Danger
Start-up/commissioning is absolutely prohibited until it has been completely ensured that the
machine, in which the components described here are to be installed, is in full compliance
with the specifications of Directive 98/37/EC.
Only appropriately qualified personnel may commission SIMODRIVE and SIMOVERT
MASTERDRIVES drive units and the motors.
This personnel must carefully observe the technical customer documentation associated with
this product and be knowledgeable about and carefully observe the danger and warning infor-
mation.
Operational electrical equipment and motors have parts and components which are at
hazardous voltage levels.
When the machine or system is operated, hazardous axis movements can occur.
All of the work carried-out on the electrical machine or system must be carried-out with it in a
no-voltage condition.
SIMODRIVE and SIMOVERT MASTERDRIVES drive units have been designed to be con-
nected to line supplies grounded through a low-ohmic connection (TN line supplies). For addi-
tional information please refer to the appropriate documentation for the drive converter
systems.
Warning
The successful and safe operation of this equipment and motors is dependent on professional
transport, storage, installation and mounting as well as careful operator control, service and
maintenance.
For special versions of the drive units and motors, information and data in the catalogs and
quotations additionally apply.
In addition to the danger and warning information/instructions in the technical customer docu-
mentation supplied, the applicable domestic, local and plant-specific regulations and require-
ments must be carefully taken into account.
Caution
The motors can have surface temperatures of over +100 °C.
This is the reason that temperature-sensitive components, e.g. cables or electronic compo-
nents may neither be in contact nor be attached to the motor.
When connecting-up cables, please observe that they
– are not damaged
– are not subject to tensile stress
– cannot be touched by rotating components.
1FK7 Synchronous Motors
Configuration Manual (PFK7), 10/2005 Edition, 6SN1197-0AD06-0BP1
Foreword
v
Advertisement
Table of Contents
