Set-Up Instructions - Newco CX-3 Operation Manual

Set up instructions for CX3 Machine
Fill and install 2lb hoppers with nozzles turned up, Chocolate on left and Milk on right.
Make sure "button" on bottom of hopper is seated in slot in sheet metal. Slight manual
rotation of the auger gear may be necessary to seat hopper in correct location.
Rotate dispense nozzles down into whipper bowl.
Turn machine on, machine should start filling, will shut off when full.
Heater will turn on when water in tank is at probe level and will display Heating: Please
Wait. When machine temperature reaches brew temp, display will change to "Ready to
Brew". If brew is initialized before tank temperature is reached, machine will display
"Preparing to Brew" until temp is reached, then will start brewing.
Place an empty cup in the brewing area, open the powdered hopper door, and depress
the "Rinse" button next to the whipper bowl until the water runs clear.
To dispense a drink, place a cup under the dispense area, press a brew selection
or the brewing drawer open button and place a pod flat side up (not necessary if
the drink selection does not use a pod) and press the button on the keypad which
corresponds to the drink desired. When the drink is finished, the machine will
beep 3 times and the display will change to "Ready to Brew"
NOTE: TO DISPENSE HOT WATER;
WILL DISPENSE UNTIL BUTTON IS RELEASED, OR TIMES OUT AT 12 SECONDS
DRINK SELECTION KEYPAD AND DISPLAY
Message
Display
Area
Product
Selection
Button
Default
Hot Water
Button
PUSH AND HOLD "HOT WATER" BUTTON...WATER
Selection
Indicator
Light
Product
Selection
Button
Brewing Drawer
Open Button
10