Programming Instructions - Newco CX-3 Operation Manual

Programming Instructions

To enter into "Programming Mode", hold the BOTTOM CENTER button while powering
up the machine with the power switch.
Select Menu
The machine readout will display in the Message Display Area.
Maintenance
Maintenance, Statistics, and Machine Setup Modes are accessible in the Programming Mode.
The following applies to screen navigation in this mode:
1) Upper 2 left buttons are for entering a menu or adjusting the parameter.
2) Upper 2 right buttons are for scrolling up/down through program screens.
3) Buttons are illuminated to indicate active buttons for input.
4) Reset button used in reset screens to reset count shown.
LOOK FOR ICONS ON DISPLAY SCREEN
These Buttons Are
Used To Enter A
These Buttons Are
Menu Choice
Used To Scroll UP &
Or Adjust A
Down Through The
Value
Menu Screens
11