Installation Instructions - Newco CX-TOUCH Operation Manual

W/qr code specialty drink single cup brewer with auto eject system

Hide thumbs Also See for CX-TOUCH:

Operation manual (29 pages)

Programming instructions (2 pages)

Manual (39 pages)

Table Of Contents

Table of Contents

WARNING:

- Read and follow installation instructions before plugging or wiring in machine to

electrical circuit. Warranty will be void if machine is connected to any voltage other than that

specified on the nameplate serial tag.

Machine must be on a flat and level surface. Plug or wire in machine to appropriate voltage

as noted on the brewer serial tag. Serial tag is located on side of machine.

With water line connected, turn machine power ON (power switch located lower right rear

of machine). Install Drip tray and drip tray grate under brew area (slide tray between guide

rails until seated).

Tank will automatically fill, and machine will start heating. If tank does not fill in 8

minutes, a "tank fill error" will occur. (Note: To reset error power machine on/off with

power switch).

Allow 10 to 15 minutes for water in tank to heat to brewing temperature. (Additional water

may drip into drip tray on initial expansion of water in the tank). This will not occur

thereafter.

Heater will turn on when water in tank is at probe level. If brew is initialized before tank

temperature is reached, machine will display "Preparing to Brew" until temp is reached,

then will start brewing.

In higher altitude locations (3000 feet above sea level) the thermostat may

have to be adjusted lower to prevent boiling:

Brew water temperature is factory set at 200o F (92.3o C) Areas of high altitude will require lowering this

temperature to prevent boiling. This chart should be used as a guide when readjusting the brew water temperature.

Altitude (Feet)

-1000

-500

500

1000

1500

2000

2500

3000

3500

4000

4500

5000

5500

6000

6500

7000

7500

8000

8500

9000

9500

10000