Set Up Instructions; Product Installation Procedure - Newco Bistro Touch BISTRO-TCH Operating Instructions Manual

This machine is intended to brew a 6-20 ounces single serving of coffee and / or
powdered hot drinks into a cup. This machine will also dispense hot water for allied
beverage use. It is intended for indoor use only on a sturdy counter or shelf.
Fill and install ingredient hoppers with nozzles turned up, Chocolate on left and Milk
on right. Make sure "button" on bottom of hopper is seated in slot in sheet metal.
Slight manual rotation of the auger gear may be necessary to seat hopper in correct
location.
Rotate dispense nozzles down into whipper bowl.

Product Installation Procedure

 Open product box and remove the BIB product Fig. 1. Place in
Coffee BIB Tray, Fig. 2, (Newco PN 121929) as shown in Fig. 3
 Remove the plastic insert from the BIB fitment as shown in Fig. 4
 Using finger and thumb only to prevent over-tightening, thread the
BIB connector on to the BIB fitment until seated as shown in Fig. 5
Place the product in the storage compartment as shown in Fig's. 6

& 7
 Position tubing as shown in Fig. 7
NOTE COFFEE BIB IS LH CONNECTOR AND DECAF BIB IS RH CONNECTOR
Fig. 4

Set up instructions

Fig. 1
SEE PAGE 5
Fig. 5
Fig. 2
Fig. 6
9
Fig. 3
Fig. 7