Replacement Of Components; Fan Replacement - IDEAL Vogue System Gen 2 S15 Installation And Servicing

3.10 REPLACEMENT OF COMPONENTS

When replacing ANY component:
1. Isolate the electrical supply
2. Isolate water connections
3. Turn off the gas supply
4. Remove the front panel
5. Swing the control panel down into the service position
After replacing ANY component check operation of the boiler,

3.11 FAN REPLACEMENT

1. Refer to Sections 3.2 & 3.3.
2. Remove the ignition, detection and earth leads.
3. Remove the 2 clips securing the gas inlet pipe and
remove the pipe.
4. Remove the fan low voltage and mains connections.
5. Remove the 4 securing nuts retaining the burner/fan
assembly.
6. Remove the assembly from the heat exchanger.
7. To remove the venturi release the 2 securing screws to
gain access for cleaning.
8. When replacing check the sealing gasket is
undamaged or replace as necessary, and secure with
the 2 screws.
9. To remove the fan, first remove the venturi as above
and release the 3 screws securing the fan to the burner.
(Note a mounting spacer is fitted to the fan outlet on
32kW model only)
10. Replace the fan and refit the venturi checking the
sealing gasket is undamaged or replace as necessary,
and secure with the 2 screws
*Note a noise damper is fitted to the venturi inlet on the
32kW models
*Note a mounting spacer is fitted to the fan outlet on
32kW.
11. Check the operation of the boiler. Refer to Sections
2.24 - 2.27.
7
50
SECTION 3 - SERVICING
9
Noise Damper
Fitted only to
32kW model
including gas tightness, gas rate and combustion
test.
IMPORTANT. when work is complete, the front
panel must be correctly refitted - ensuring that a
good seal is made.
THE BOILER MUST NOT BE OPERATED
WITHOUT THE FRONT PANEL FITTED.
5
3
4
3
2
Mounting Spacer
Fitted only to
32kW model
Installation and Servicing
5