Leica CM3050 S Instruction Manual page 60

9. Appendix
1.4 Installation
When placing the instrument onto
the U-frame, make sure the power
cord does not get caught and thus
crushed between U-frame and cry-
ostat housing.
60
• Open the shipping box and remove all packing material including the Sty-
rofoam pieces.
• Take the height adjustment device out of the box.
• At the place of installation, place the U-frame on the floor with the open
side facing yourself. Adjust the U-frame parallel to the wall, maintaining a
distance of approx. 10 cm between wall and U-frame.
• Push the (ab) button to lower the height adjustment device to the lowest
possible position.
• In order to be able to move the instrument,
use a fork wrench and unscrew the rollers
on which the Leica CM3050 S moves by
about 2 cm.
• Roll the cryostat onto the U-frame as far as it
will go. The rear of the cryostat housing has
to fit closely to the rear bar of the U-frame.
• Roll the cryostat onto the U-frame as far as it
will go. The rear of the cryostat housing has
to fit closely to the rear bar of the U-frame.
• Plug the height adjustment device into the
mains socket. The unit is now ready for use.
Instruction Manual V1.2 - 11/2006