Appendix; Getting Started With Iar - Microchip Technology ATmega4809 Xplained Pro User Manual

5.

Appendix

5.1

Getting Started with IAR

IAR Embedded Workbench
GCC. Programming and debugging of Xplained Pro kits are supported in IAR
AVR using the Atmel-ICE interface. Some initial settings must be set up in the project to get the
programming and debugging to work.
The following steps will explain how to get your project ready for programming and debugging:
1. Make sure you have opened the project you want to configure. Open the OPTIONS dialog for the
project.
2. In the category General Options, select the Target tab.
listed, the core of the
3. In the category Debugger, select the Setup tab.
4. In the category Debugger > Atmel-ICE, select the Atmel-ICE 1 tab.
and optionally select the UPDI
Info: If the selection of Debug Port, mentioned in step 4, is grayed out, the interface is pre-
selected and the user can skip this configuration step.
Figure 5-1. Select Target Device
©
2018 Microchip Technology Inc.
® ®
for AVR is a proprietary high-efficiency compiler which is not based on
device.
frequency.
User Guide
ATmega4809 Xplained Pro
™
Embedded Workbench for
Select the device for the project, or, if not
Select Atmel-ICE as the
Select UPDI as the interface
Appendix
driver.
DS50002716A-page 24