Set The Limit - Fluke MultiFiber Pro Getting Started Manual

If the display shows
low on one or more channels. This can be caused by a
bad connection or incorrect settings on the source. See
the Users Manual.
Do not disconnect test cord 1 from the source after
you set the reference.
Reference Connections for Multimode Permanent Links

Set the Limit

The meter compares loss measurements to a limit to give a
status of OK or
channel exceeds the limit,
channel flashes, and the bargraph shows an oval above the limit
line on the display.
To set the limit
1 On the meter, hold down
menu, press

press


Pinned/Pinned
Meter
with Unpinned MTP/MPO Connectors

to the measurements. If a measurement for a


to put the cursor next to LOSS LIMIT, then
to put the meter in the loss limit mode.

and , the power level is too
Caution
Type B
Test cord 1
Source
flashes, the bargraph for that

for 4 seconds to see the setup
How to Measure Loss
-continued-
GUF00.EPS
13