Installation Instructions - HEATSTRIP THE 1800 Operation, Installation, And Maintenance Manual

Installation Instructions

Ensure all minimum clearance requirements are met and the
materials used are compliant to your local building codes.
Before installing the FME, ensure the site to be fixed is fully
prepared with the hole cut the correct size and the mounting
points securely in place.
STEP 1: Attach the brackets to
the rear of the heater. The di-
mensions for the spacing of the
brackets are listed in the table.
STEP 2: Screw the FME into the
battens. NOTE: screws are not
included.
STEP 3: If there is no roof ac-
cess, connect the heater to the
power source, ensure the power
is OFF.
STEP 4: Lift the heater into the
FME ensuring the brackets are to
the side of the mounting cut-outs.
STEP 5: Push the heater to the
left ensuring the brackets engage
in the mounting hole cut-outs. It
will then drop in. Gently shake
the heater to ensure that it is se-
curely mounted.
6
MODEL
"D"
DISTANCE FROM END
TO BRACKET (mm)
THE1800
THE2400
THE3600
175
225
300