Maintenance - HEATSTRIP THE 1800 Operation, Installation, And Maintenance Manual

Safety
In operation, this heater is VERY HOT— do not touch any part of the heater while it is turned on. Do
not touch any part until 30 minutes after it is turned off.
This appliance is not intended for use by persons (including children) with reduced physical, sensory
or intellectual capabilities, or lack of experience and knowledge, unless they have been given super-
vision or instruction concerning use of the appliance by a person responsible for their safety. Children
should be supervised to ensure they do not play with the appliance.
Do not allow any cables, furnishings, flammable materials or other items come in contact with any
surface of the Flush Mount Enclosure.
If installed in wet areas, the heater switches or controls must be located so that they cannot be
touched by persons in the bath or shower.
The Flush Mount Enclosure needs to be installed as per the installation instructions paying special
attention to the minimum clearances. The heater needs to be mounted on a rigid bracket or fixing.
See the heater Operations, Installation and Maintenance Manual for the heater specific guidelines.

Maintenance

The Flush Mount Enclosure is made from durable materials, however regular care and maintenance
of your product will help prolong its life.
It is recommended that you wipe down your Flush Mount Enclosure. With a soft cloth and mild deter-
gent gently wipe the surfaces of the FME to remove the built up contaminants from the environment.
Then with a clean cloth ensure all detergent is removed.
All chemicals in the atmosphere including cigarette smoke, pollution etc. will tarnish the surface of
the Flush Mount Enclosure. In this case, additional cleaning and maintenance may be required. The
cleaning process at least every three months will reduce the amount of build up and keep it looking
as best it can. If the Flush Mount Enclosure is in a corrosive environment eg. salt spray, we recom-
mend that you clean the FME every week.
Before cleaning or inspection activity, the heater must be switched off and cooled down completely.
Do not use any abrasive materials or products to clean the Flush Mount Enclosure, this includes sol-
vents, citrus based cleaners or other harsh cleaning products.
When handling the Flush Mount Enclosure, ensure that your hands are clean or that you use clean
gloves as grease or dirt can mark the surface of the heater.
Do not use high pressure water to clean Flush Mount Enclosure. It is not recommended to hose
down the FME and heater as water may penetrate the roof cavity.
7