Advertisement
FIGURE 9
25
3/8 X 1-3/4"
18
20
10
S T ` ` ` ` `
• Run the CABLE under and around the 4-1/2" PULLEY (29) as shown in FIGURE 9.
• SECURELY assemble the 4-1/2" PULLEY (29) to the bracket on the HEAD PLATE (10) using one 3/8 X 1-3/4" BOLT (37), two
BLACK RH CAPS (25), two 3/8" RH WASHERS (20) and one 3/8" LOW HEIGHT LOCK NUTS (18) as shown in FIGURE 9.
(NOTE: To adjust cable tension, disassemble the 4-1/2" PULLEY (29) and loosen both jam nuts under the bracket on
the HEAD PLATE (10). Adjust the bolt accordingly. Retighten jam nuts and reassemble the 4-1/2" PULLEY (29).
• The WEIGHT STACK LABEL sheet (23) includes labels for both lbs. and kgs. for both the standard and optional weight stacks.
• Peel the backing off the WEIGHT STACK LABELS (23), line up sheet to the right of the selector opening and apply labels to
the WEIGHT PLATES (34), starting with the HEAD PLATE (10) as shown in FIGURE 9.
1
29
6
37
34
10
12
9
5
21
TIGHTEN!
21
2
23
7
Advertisement
