Advertisement
FIGURE 8
8
31
30
TIGHTEN!
1
34
STEP 8:
• SECURELY assemble the GUIDE ROD SUPPORT (8) to the TOWER (1) using four RH CAPS (39), two 3/8 X 2-1/2" BOLTS
(12), four 3/8" RH WASHERS (20) and two 3/8" LOW HEIGHT LOCK NUTS (18) as shown in FIGURE 8.
• Slide GUIDE ROD BUSHINGS (31) into the tubes on the GUIDE ROD SUPPORT (8), slide 1" SHAFT COLLARS (30) under-
neath the GUIDE ROD BUSHINGS (31) and SECURELY tighten the set screws.
• Insert the WEIGHT STACK PIN on the HEAD PLATE (10) into the WEIGHT STACK (34) as shown in FIGURE 8.
18
11
20
12 3/8 X 2-1/2"
10
39
Advertisement
