Table of Contents
Advertisement
Section
User Codes
[01]
Installer Code
[02]
Master Code
[03]
User Code 01
[04]
User Code 02
[05]
User Code 03
[06]
User Code 04
[07]
User Code 05
[08]
User Code 06
[09]
User Code 07
6.7
PANIC ALARMS
The panic alarm, if programmed, will immediately generate an alarm after pressing and holding the [1] and [3] keys for two seconds (see section
4.4) (disabled by default).
6.8
ALARM MEMORY DISPLAY
A record of the zones that were in alarm the last time the system was armed will be stored in memory. After disarming the system, press the
[
] button to display the zones that were in alarm. To exit the Alarm Memory Display, press the [
MEM
contents of the alarm memory every time the system is armed.
[5]
Zone
will illuminate if an alarm has occurred on the keypad zone or if the keypad's on-board tamper was triggered (see section 2.10).
The control panel cannot distinguish the difference between the two. Zone
were pressed.
6.9
PROGRAMMING CHIME ZONES
Press and hold any key from [1] to [5] for 3 seconds to activate or deactivate Chiming for zones 1 to 6. For example, press and hold the [1] key
to enable chiming on zone 1. If after pressing and holding a key, the keypad emits a confirmation beep, the chime feature has been enabled for that
zone. If the keypad emits a rejection beep, the chime feature has been disabled for the corresponding zone.
6.10
KEYPAD MUTING
Press and hold the
pressed and when the keypad emits a rejection or confirmation beep. All other beep functions are disabled.
To program the Spectra 1727 control panel, use a keypad to enter the Programming Mode as shown below.
STEP 1: Press [
ENTER
STEP 2: Enter your [
STEP 3: Enter the 2-digit [
STEP 4: Enter the required [
USER CODES
Sections [02] to [09] can only be programmed by the System Master Code (see section 5.4).
Section #
[01]
Installer Code
[
]
[
ENTER
CURRENT INSTALLER CODE
+
10 Complete Installation Manual
Table 4: Pre-programmed Options for User Codes
Change Code
[
]
CLEAR
button for 3 seconds to enable or disable keypad muting. When muted, the keypad will only beep when a key is
7:
PROGRAMMING GUIDE
DEFAULT INSTALLER CODE: 0000/000000
DEFAULT SYSTEM MASTER CODE: 1234/123400
How Do I Enter Programming Mode?
]
] (default: 0000/000000) or
INSTALLER CODE
] you wish to program
SECTION
]
DATA
Can
Can
Reg. Arm
[
SYSTEM MASTER CODE
]
+ [01] + new 4- or 6-digit Installer Code
Can
Can
Disarm
Bypass Arm
] button. The control panel will erase the
CLEAR
[8]
will illuminate if the panic alarm keys (see section 4.4)
]
(default: 1234/123400)
Can
Can
Stay Arm
Force Arm
Hide quick links:
Advertisement
Table of Contents
