Paradox Esprit 728 ultra Programming Manual

INSTALLER CODE (Default: 282828)
Full access to programming, except user access codes (PINs). No access to arming/disarming. Use only numeric keys from [0] to [9].
ZONE RECOGNITION
STREAMLINED SECTION PROGRAMMING
This is an alternate method to Hexa Programming (see page 2). Addresses 000 to 043 and 300 to 527 are grouped into 67 sections where
each section contains four addresses (i.e. section 00 = addresses 000 to 003). Using this method allows you to program 8 digits (4
addresses) without having to exit and reenter addresses.
Note, the keypad will not display the current data in the Streamlined Section Programming method.
1)
2)
3)
4)
5)
6)
7)
KEYPAD TROUBLE DISPLAY
Press the [ ]/[ ] key to view the trouble. Any illuminated keys represent a specific trouble as indicate in Table 3 below. Press the
TBL TRBL
[ ] button to exit the trouble display.
CLEAR
[1]
[2]
[4]
[5]
[6]
S P
YSTEM ROGRAMMING
Table 1: Zone Recognition
Device connected to which input?
Control Panel
Input 1 =
Input 2 =
Input 3 =
Input 4 =
Keypad
Zone 1 =
Zone 2 =
Table 2: Streamlined Section Programming Method
Press [ ] + [
ENTER INSTALLER CODE
The [ ] and [2 ] keys will flash to indicate you are in programming mode
ENTER ND
Enter 2-digit [ ] (00 to 67)
SECTION
The [ ] key will remain on while the [2
ENTER
Enter 8-digit [ ] to program the section
DATA
The keypad will "beep" to indicate that the section has been programmed, data is
saved and the software has advanced to the next section
Return to step 4 or press [
- No Battery or Low Voltage
- Power Failure
- Bell Output Disconnected
- Exceeded Maximum Bell Current
- Exceeded Maximum Auxiliary Current
Esprit 728 Ultra - 1 - Programming Guide
G
UIDE
Software Version 4.0
No ATZ
Zone 1
Zone 2
Zone 3
Zone 4
Zone 5
Zone 6
] (default: 282828) + [7]
] key will be off
ND
] to exit programming mode
CLEAR
Table 3: Trouble Display
[7]
- Communicator Report Failure
[8]
- Timer Loss* (to clear, see
in Table 11 on page 11)
[9]
- Tamper or Zone Wiring Failure
[10]
- Telephone Line Monitoring Failure
[11]
- Fire Loop Trouble
(728ULT)
With ATZ
Zones 1 & 2
Zones 3 & 4
Zones 5 & 6
Zones 7 & 8
Zone 9
Zone 10
[ ]
MEM key