Bypass Recall Feature; One-Touch Arming; Keyswitch Arming; Panic Alarms - Paradox Spectra 1725 Programming Manual

BYPASS RECALL FEATURE

After disarming the system, the control panel will erase the bypass entries. By using the Bypass Recall Feature, you can
reinstate the previous bypass entries saved in memory. This eliminates the need to manually program the bypass entries
every time you arm the system.

ONE-TOUCH ARMING

One-Touch Arming allows users to arm the system without the use of an access code, simply press and hold a button. One-
Touch Arming can be used to allow specific individuals like service personnel (i.e. cleaners, maintenance) to arm the system when
leaving the protected area, without giving them access to any other alarm system operations.
One-Touch Regular Arming
Press and hold the [
One-Touch Force Arming
Press and hold the [
One-Touch Bypass Programming
[
Press and hold the
One-Touch Stay Arming
Press and hold the [
Fast Exit - When the system is already Stay Armed:
To Exit and Stay Arm: Press and hold the
the end of the Exit Delay period, the system will return to Stay Arming.
To Exit and Regular Arm: Press and hold the [
At the end of the Exit Delay period, the control panel will switch to Regular Arming.
To Exit and Force Arm: Press and hold the
At the end of the Exit Delay period, the control panel will switch to Force Arming.
* If you have access to both partitions after activating a one-touch feature, press the button corresponding to the desired
partition. To select both partitions, press the [1] key then after the confirmation beep press the [2] key.

KEYSWITCH ARMING

A keyswitch can be used to arm and disarm the system. Assign the keyswitch to a specific partition and program the
keyswitch to Stay or Regular Arm the assigned partition. Also program the keyswitch to function as a Maintained or
Momentary keyswitch. To arm the system using a Maintained Keyswitch, set the keyswitch to the "on" position. To disarm the
system set the keyswitch to the "off" position. To arm the system using a Momentary Keyswitch, set the keyswitch to the "on"
position then turn it back to the "off" position. Repeating this sequence will disarm the system.

PANIC ALARMS

In case of emergency, the Spectra system provides up to three panic alarms. These panic alarms, if programmed, will
immediately generate an alarm after pressing and holding two specific buttons for two seconds, as described below.
Press and hold buttons [1] and [3] for a panic alarm.
Press and hold buttons [4] and [6] for a panic or medical alarm.
Press and hold buttons [7] and [9] for a panic or fire alarm.
How Do I Recall Bypass Entries?
1) Press the [ ] button.
BYP
2) Key in your [
ACCESS CODE
3) Press the [ ] button.
BYP
4) Press the [ ] button.
ENTER
*If you have access to both partitions, press the button corresponding to the desired
partition. The Access Code must have the Bypass Programming Option enabled.
] button for 3 seconds* to arm all zones in the partition.
ENTER
] button for 3 seconds* to bypass any open Force Zones.
FORCE
] button for 3 seconds* to access Bypass Programming Mode.
BYP
] button for 3 seconds* to arm all zones not defined as Stay Zones.
STAY
]*
[ ] button for 3 seconds*. The system will switch to Exit Delay mode. At
STAY
] button for 3 seconds*. The system will switch to Exit Delay mode.
ENTER
[ ] button for 3 seconds*. The system will switch to Exit Delay mode.
FORCE
33
Spectra Series