Kodak DryView 8150 User Manual page 71

Restore Configuration
October 4, 2004
This menu choice allows you to restore the Imager configuration
parameters from a previously-recorded backup file.
The backup file is usually recorded on a floppy disk but can also be
recorded on the Imager hard drive or on a remote network drive if
accessible on the network.
The Service passcode is required.
Restore procedure (from floppy disk):
You must have a previously-recorded backup disk.
1. From the Home screen, touch Menu.
2. Touch Set Up Imager.
3. Touch No when a message prompts to Use the Installation
Assistant.
4. If you are not logged in, enter the Service ID and Service Passcode on
the two keypads that appear.
The Setup Imager screen appears
5. Select Restore Configuration.
7F3319
Operation and Maintenance
2-37