Kodak DryView 8150 User Manual page 130

Adding a Modality
4-6
10. Wait for the Imager to print the image sent from the modality.
• The imager will attempt to find an appropriate set of parameters for
the modality in its internal database of modality parameters.
• If no parameter set is found for the modality, the Imager uses a
universal set of parameters to print the test image.
11. Examine the quality of the print. Determine if it is acceptable.
12. On the Select Modality screen
printed the image.
13. Is the quality of the print acceptable?
• If acceptable, touch No (do not use the modality installation
assistant). Go to
• If not acceptable, touch Yes (use the modality installation
assistant).
You will now see a series of screens that will allow you to enter the
Manufacturer, Type and Model of the modality. The Imager will use
this information for a second search of its parameter database.
7F3319
(page 4-4), select the modality that
"Changing the Modality ID" on page 4-10.
October 4, 2004