October 4, 2004
b. Push the optics module toward the rear of the imager slowly and
smoothly.
Optics
Module
c. Clear the film from inside the platen. If film is caught in the platen
feed rollers, pull Plastic Thumb Tab 1 (inside the platen door) to the
right. This opens the rollers and frees the film.
d. After clearing the jam, close the platen door.
5. If film is stalled in the vertical transport area, pull Plastic Thumb Tab 2
in this area to the right to open the rollers and free the film.
6. Close the front door.
7F3319
Troubleshooting
10 cm (4 in.)
3-13