Check-line DTMX-200 Manual page 4

3.00 DESCRIPTION OF MEMBRANE KEY FUNCTIONS
Key Description of Functions
• Starts/Stops scanning for Max/Min/Peak values. (Standard Memory)
STORE
• Starts/Stops automatic recording of values into memory (Continuous Data Logging Model).
•
• Enters Recall Mode to review statistics and recorded Data.
•
RECALL
MAX etc.
MAX MIN
DATA #1 DATA #2
POWER • Turns power on.
EXIT
• Turns power off if pressed and held for 5 or more seconds.
• Exits from Recall Mode when reviewing statistics and data.
DATA • Initiates downloading of data.
OUT
+
• Clears all data in Basic Memory and Extended Memory ("CCCC" momentarily shown
STORE
RECALL
on display).
POWER
+ • Zeros gauge ("Tare") for use in any orientation ("Gravity Correction").
RECALL
EXIT
3.10 Auxiliary Functions
Key
*
• Changes units of measure from grams (or Kg) to pounds (or ounces) and back again
POWER
+
STORE
each time this key combination is pressed.
EXIT
• Changes from Tension Measurement Mode into Thickness Measuring Mode when
POWER DATA
+ both keys are pressed and held for four or more seconds.
EXIT OUT
• Exits Material Thickness Mode and returns to Tension Measuring Mode.
STORE
* When the units of measure are changed to grams, the "gf" indicator will
momentarily flash on and then turn off. Otherwise the "lb." or "oz" indicators
will be shown.
4
Loads displayed value into memory (On-Demand Data Logging Model).
In recall mode, changes display from LAST MAX MIN
• When in Data Logging Mode: changes display from LAST
PEAK. AVERAGE STANDARD DEVIATION
DATA #3 etc.
Description of Functions
9.55 Analog Cable
The CA cable is for connection to chart
recorders or other recording devices.
It is supplied with bare leads for easy
connection to a wide variety of devices.
9.56 AC Adapter.
PEAK LAST
This adapter is for use during long-term,
on-line measurements to save battery power.
It connects to 115 VAC power sources.
9.57 Special Calibration
If the standard Factory Calibration and the
Field Calibration Adjustment does not
provide the desired accuracy, a Special
Calibration can be ordered. Up to two
Special Calibrations can be provided (SP1
and SP2). A l0' sample of the process
material(s) must be provided for calibration
purposes.
9.60 On-Line Mounting Holes
The DTMX is supplied with two threaded
holes for on-line mounting in a fixed posi-
tion when performing measurements over
an extended period.
Thread Size
Thread Depth
M5 (metric)
7.5 mm (max.
CA
AC
SP
W
Mounting
holes
29