Microwave Data Systems MDS TransNET 900 Installation & Operation Manual page 74

connected 43
Peer (radio diagnostics type) 31, 44
Performance optimization 19
Pins, DATA INTERFACE connector
descriptions (table) 55
Point-to-point system
link, illustrated 4
PORT command (set/display current
data port) 32
Power (RF)
how much can be used 12
Measurement 36
set/display RF forward output (PWR
command) 34
Power saving mode (see Sleep Mode)
Procedures
antenna aiming 20
antenna and feedline selection 10
antenna SWR check 20
connecting data equipment to DATA
INTERFACE connector 14, 21
connecting PC and radios for
network-wide diagnostics 43
enabling sleep mode
installation 13-18
installation planning 6
installing the antenna and
feedline 14
interference check 21
mounting the transceiver 13-14
network-wide diagnostics 43
performance optimization 19
performing network-wide
diagnostics 43
programming radio for network-wide
diagnostics 43
reading LED status indicators 19
site selection 7
troubleshooting 39-42
Programming radio 27-38
as root or node 43
PWR command (set/display RF forward
output power) 34
R
Radio
inoperative (troubleshooting
chart) 42
no synchronization with master
(troubleshooting chart) 42
I-4 MDS TransNET 900 I&O Guide
poor performance (troubleshooting
chart) 42
Remote radio
default settings 33
Remote station
typical arrangement, illustrated 7
Repeater Operation. See
Store-and-Forward (SAF)
Root (radio diagnostics type) 31, 44
RSSI command (display received signal
strength) 34
RTU command (enable/disable internal
RTU) 35
RX command (set/display test receive
frequency) 35
RXTOT command (set/display received
data timeout value) 35
S
SAF command (store-and-forward) 35
See also Encryption 29
Set
alarm output sense (ASENSE
command) 28
alarm output signal (AMASK
command) 28
CTS hold timer (CTSHOLD
command) 30
CTS line response timer (CTS
command) 29
data interface baud rate (BAUD
command) 28
DCE or CTS Key device behavior
(DEVICE command) 30
frequency zone to skip (SKIP
command) 36
hoptime (HOPTIME command) 31
network address (ADDR
command) 27
owner's message (OWM
command) 32
owner's name (OWN command) 32
radio mode (see MODE
command) 32
received data handling mode (BUFF
command) 28
received data timeout value (RXTOT
command) 35
test receive frequency (RX
command) 35
MDS 05-2708A01, Rev. B