Port - Microwave Data Systems MDS TransNET 900 Installation & Operation Manual

Table 8. Operating Status—Display Only (Continued)
Command
CTS
Details page 29
CTSHOLD
Details page 30
DEVICE
Details page 30
HOPTIME
Details page 31
HREV
Details, page 32
MODE
Details page 32
OWM
Details page 32
OWN
Details page 32

PORT

Details page 32
PWR
Details page 34
REPEAT
Details page 34
RETRY
Details page 34
SAF
Details page 35
SKIP
Details page 36
RSSI
Details page 34
RXTOT
Details page 35
MDS 05-2708A01, Rev. B
Description
CTS delay in milliseconds (0–255 ms)
"Hold time" that CTS is present following last
character from DATA port.
Device behavior
Alternatives: DCE and CTS KEY
Hop-time value in milliseconds (ms).
Hardware revision level
Current operating mode:
M = Master
R = Remote
X = Extension (Repeater)
Owner's message or site name
Owner's name or system name
Current data port (DATA connector) interface
signaling mode: RS232 or RS485
Forward power-output setting in dBm
The fixed downstream re-send count.
The maximum upstream re-send count for
ARQ (Automatic Repeat Request) operation.
The store-and-forward function status.
Table of frequency zones programmed to be
skipped
Received signal strength indicator (dBm).
Unavailable at Master unless SETUP is
enabled.
The amount of time (in seconds) to wait before
issuing a time-out alarm.
MDS TransNET 900 I&O Guide 25