Model Configuration Codes - Microwave Data Systems MDS TransNET 900 Installation & Operation Manual

• Network-wide configuration from the master station; eliminates most
trips to remote sites
• Data transparency–ensures compatibility with virtually all
asynchronous SCADA system RTUs
• Peak-hold RSSI, averaged over eight hop cycles
• Operation at up to 115,200 bps continuous data flow
• Store-and-Forward repeater operation
• Data latency typically less than 10 ms
• Same hardware for master or remote configuration
• Supports RS/EIA-232 and RS/EIA-485 user interface
• Low current consumption—Less than 8 mA in "sleep" mode.
NOTE:
Some MDS TransNET 900 radio features may not be available on all radios,
based on the options purchased and the applicable regulatory constraints for
the region in which the radio will operate.
2.2 Model Configuration Codes
The model number code is printed on the radio enclosure, and provides key
information about how the radio was configured when it left the factory. See
Figure 2 for an explanation of the model number characters. (Note: This
information is subject to change and should not be used for product ordering.)
OPERATION
(X) Remote/Master
BAND
(9) 900 MHz
EL805 9
ENCLOSURE
(1) With Enclosure
Figure 2. MDS TransNET 900 transceiver model configuration codes
2 MDS TransNET 900 I&O Guide
AGENCY
(N) None
(F) FCC/IC
X 1 A
OPTIONS
(A) None
MTG. BRACKETS
(A) Standard
(B) None
N N
SAFETY CERT.
OPTION
(N) N/A
(N) None
(F) UL/CSA
MDS 05-2708A01, Rev. B
N
SPARE
(N) None
DIAGNOSTICS
(N) None
(W) Network-wide