Table of Contents
Advertisement
6. Installation Instruction
a). The operating temperature of this device is -15
10%~95%, please use the device not exceed this range.
b). The installation of the effect has to be built and constructed in a way that it can hold
10 times the weight for 1 hour without any harming deformation.
c). Never stand directly below the device when mounting, removing or servicing the
fixture.
d). The operator has to make sure the devices are properly connected according to this
manual
Installtion Instruction：
a) Fixed the clamp on the bracket by tighten up the M12 screw on the bracket to the Ф13
hole in the middle of the bracket.
b) Insert the quick-lock fasteners of the first Omega holder into the respective holes on
the bottom of the device. Tighten the quick-lock fasteners fully clockwise.
c) Install the second Omega holder.
d) Pull the safety-rope through the holes on the bottom of the base and over the trussing
system or a safe fixation spot. Insert the end in the carabine and tighten the safety
screw.
o
C ~ 50
o
C and moisture within
5
Advertisement
Table of Contents
