Installation - Elation DTW BLINDER 700 IP User Manual

I N S TA L L AT I O N
C A U T I O N S
ENSURE ALL CONNECTIONS AND END CAPS ARE PROPERLY SEALED WITH A
DIELECTRIC GREASE (AVAILABLE AT MOST ELECTRICAL SUPPLIERS) TO PREVENT
WATER CORROSION AND/OR ELECTRICAL SHORT CIRCUIT.
• For added protection, mount the fixture in areas outside walking paths, seating areas, or
in areas where unauthorized personnel might reach the fixture.
• Ambient operating temperature range for this fixture is
Do not use the fixture under or above this temperature.
• Before mounting the fixture to any surface, make sure the installation area can hold a
minimum point load of 10 times the weight of the fixture.
• Fixture installation must always be secured with a secondary safety attachment, such as
an appropriate safety cable.
• Never stand directly below the device when mounting, removing, or servicing.
F L A M M A B L E M A T E R I A L W A R N I N G
Keep fixture at least 5.0 ft (1.5m) away from any
flammable materials, decorations, pyrotechnics, etc.
E L E C T R I C A L
A q u a l i f i e d e l e c t r i c i a n s h o u l d b e u s e d f o r a l l
e l e c t r i c a l c o n n e c t i o n s a n d / o r i n s t a l l a t i o n s .
C O N N E C T I O N S
5° to 113°F. (-15° to 45°C)
11