Dmx-512 Control Connection - Elation EPV762 MH User Manual

Notice: this step is quite important to ensure that the fixture will not drop out
by the damage of the clamp.
7. DMX-512 control and signal connection

DMX-512 control connection

Connect the provided XLR cable to the female 3-pin XLR output of your controller and the
other side to the male 3-pin XLR input of the moving head. You can chain multiple
Moving head together through serial linking. The cable needed should be two core,
screened cable with XLR input and output connectors. Please refer to the diagram below.
Starting address 1 Starting address 7 Starting address 13
Signal connection
For signal connection, please connect the signal cable end to led display transmitter first
outlet, a master card to connect to the led display of the engine signal inputs. from the
first screen of the signal output is connected to the second block display output, and so
on, until all display attached. The signal cable must be reticle connected to mother card
respectively, Please see the following signal connection picture:
6