Eneo TER-12N040200A User Manual page 41

41 | Full HD Digital Video Recorder
4.2.6 PTZ
1) Connect PTZ
Full control and setup of supported PTZ cameras is available in this menu. For more information on controlling PTZ cameras
in live mode, see section 3.4 PTZ. Use this setup menu to setup a PTZ camera, adjust the camera's zoom, focus and iris (on
supported models), adjust the pan, tilt and zoom control speed, or setup presets pan, tour and guard schedules.
Adding a PTZ camera: Once a PTZ camera is properly connected to the DVR using the RS485 ports, go to the PTZ setup
menu and adjust the following values:

Protocol- Select the proper protocol of the connected PTZ camera from the supported drop down menu options.
- PELCO-C AHD : All AHD protocol
- PELCO-C TVI 1 : This is PELCO-C protocol and to enter the access by Iris Open.
- PELCO-C TVI 2 : This is PELCO-C protocol and to enter the access by Preset 95
- TVI-C

Address- Set the PTZ driver address of the connected camera. This address must match the PTZ's address.

Baud rate- User can select the baud rate level from 1,200bps up to 115,200bps.

Troubleshooting- if the camera is unresponsive, check the following:
1. The protocol of the PTZ camera is correct and matches the one selected on the DVR.
2. The communication settings, including the baud rate, of the PTZ camera are in accordance with the assigned values
on the DVR.
3. The address of the PTZ camera is correct and matches the one selected on the DVR.
4. The wiring to the PTZ controllers are correct and the cables are intact.
2) PTZ set up

Controlling a PTZ camera: To check the 'USE PTZ MENU' mode on the UTC/PTZ tab. Once the camera is properly
connected and configured, use the following setting options as needed:

Zoom, Focus and Iris- on supported models, use the + and –to adjust the camera's lens.

Directional arrows- use these arrows to move the camera to a desired position or control the camera's OSD menu (on
supported models).

Pan, Tilt and Zoom speed- Use the bars for each option to adjust the control speed. The higher the number, the more
sensitive the camera will be to control commands from the DVR, and move faster.
And the other control is same as PELCO-C TVI 2
: Hikvision TVI protocol