Table of Contents
Advertisement
-
Date/ Time- manually enter the DVR's date and time,
time zone, and enable/ disabled DST.
Using the available options, manually adjust the date
and time from the calendar, select the display mode for
the time, and the date, and select the appropriate time
zone. If applicable, check the 'USE DST' box. See
section 3.12 DST Setting for more information.
-
HD Resolution- Select the DVR's output resolution.
DVRs support the following video resolutions: 1024x768,
1280x1024, 1920x1080.
User must set the proper resolution according to the monitor resolution
-
Language- Select the DVR's display language from the availanle in the drop-down menu.
-
Remote ID- Set the DVR's remote ID. This ID should be the same as the IR Remote Control.
-
Firmware Version & system upgrade- when a new version is available, use the easy upgrade menu to upgrade your
DVR to the latest version. To upgrade your system, follow one of the options below:
Upgrading system using USB memory stick:
1.
Insert the USB thumb-drive formatted by FAT32 in any USB port of DVR (compatible with USB 2.0)
2.
Once the system detects the thumb-drive, user can see its brand or model name in the "DEVICE" field after
pressing the "SCAN" button.
3.
Click "OK" to confirm.
Upgrading system using FTP server:
1.
Select FTP in the drop-down list and type a given IP address in the Host Address . Username and password
is "none" (Default).
*The FTP server address is subject to change without a prior notice.
2.
Click 'Check' button then DVR will detect the latest Firmware version from the FTP server. If there is a new
firmware, DVR will ask you whether you want to upgrade it or not.
3.
Click 'OK' to confirm it and then click 'START'
to start upgrading.
C
AUTION
It is recommended to format the HDD after finishing the firmware upgrade because the data recorded
by previous firmware may cause malfunction of DVR due to different format.
It is highly recommended to check all functions and menus after a firmware upgrade for proper layout
and performance. If necessary, you can return system to its default settings.
-
Video Signal- Displays the video out signal from the DVR.
-
DVR's IP & MAC Addresses- This information is necessary when connecting to the DVR via its web viewer or the
CenPro Software. See section 4.4 Network for more information and configuration options.
-
Keyboard setup- Setup the DVR's ID, baudrate and model to match the information of the keyboard you would like to
use. The Keyboard's ID must match the ID set in the DVR.
User's Manual | 32
Advertisement
Table of Contents
