Table of Contents
Advertisement
S
S
UPER
ERVER 8016B-TLF User's Manual
5-6
Installing Memory
CAUTION! Exercise extreme care when installing or removing DIMM
!
modules to prevent any possible damage.
Memory Support
The X8QBE-LF supports up to 1 TB of registered ECC DDR3-1066/978/800 memory
in 32 DIMM slots. Use memory modules of the same type, speed, timing and same
on a serverboard. Please refer to the product page on our web site for possible
updates to memory support.
Note: See the table belows for memory installation.
Installing Memory Modules
1.
Insert the desired number of DIMMs into the memory slots, starting with P1-
DIMM #A1. The release tabs on the slot should be pushed outward.
2.
Insert each DIMM module vertically into its slot. Pay attention to the notch
along the bottom of the module to avoid installing incorrectly (see Figure 5-4).
3.
Gently press down on the DIMM module until it snaps into place in the slot.
Make sure that the side notches of the DIMM modules align with the lock/
release tabs of the slot when pressed in. Repeat for all modules.
4.
Reverse the steps above to remove the DIMM modules from the serverboard.
Figure 5-3. Installing DIMMs
Release
5-8
Notches
Release
Lock/Release Tabs
Advertisement
Table of Contents
