Notes And Restrictions; Adding Pci-E Add-On Cards - Supermicro SUPERSERVER 8016B-TLF User Manual

DIMM Slots DIMMs
per DDR Populated
Channel per DDR
Channel
1 1
2 1
2 2
Population Rules:
1. Any combination of x4 and x8 RDIMMs with 1 Gb or 2 Gb DRAM density are supported.
2. Populate DIMMs starting with DIMM1A.
3. When mixing QR with SR or DR on the same DDR channel, put the QR in DIMM1A fi rst.

Notes and Restrictions

•
Only DDR3-1066 RDIMMs are validated at speeds of 800, 978, 1066 MHz.
•
For the memory modules to work properly, please install DIMM modules in pairs
(with an even number of DIMMs installed).
•
All channels in a system will run at the fastest common frequency.
5-7

Adding PCI-E Add-On Cards

The 8016B-TLF can accommodate one PCI-Express 2.0 x16 card with the use of
the CSE-RR1U-E16 riser card inserted into the PCI-E x16 slot.
Installing an Add-on Card
1. Begin by removing the PCI slot shield for the slot you wish to populate.
2. Fully seat the card into the riser card slot, pushing down with your thumbs
evenly on both sides of the card.
3. Finish by using a screw to secure the top of the card shield to the chassis.
The PCI slot shields protect the serverboard and its components from EMI
and aid in proper ventilation, so make sure there is always a shield covering
each unused slot.
Chapter 5: Advanced Serverboard Setup
RDIMM Support
RDIMM Type POR Speeds (in
(RDIMM: Reg.= MHz)
Registered)
Reg. ECC DDR3 800,978, 1066
Reg. ECC DDR3 800,978, 1066
Reg. ECC DDR3 800,978, 1066
5-11
Ranks per DIMM
(Any Combination)
SR, DR, or QR
SR, DR, or QR
Mixing SR, DR, QR