Rd433Hctx-2 Transmitter; Up; Down; A-V-O (Amps-Volts-Ohms) - Radiodetection RD400PDL-2 User Manual

RD433HCTX-2 Transmitter

Lf
8k
33k
65k
User Hz
Radiodetection
Radiodetection Ltd. Radiodetection Corp.
Western Drive PO Box 623
Bristol BS14 0AZ, UK Ridgewood, NJ07451, USA
On/Off
A-V-O
Line Select
Serial No.
Connect
01/MH1054L1ENG/2
%
Lf
8k
33k
65k
User Hz
Radiodetection
Radiodetection Ltd. Radiodetection Corp.
Western Drive PO Box 623
Bristol BS14 0AZ, UK Ridgewood, NJ07451, USA
On/Off
A-V-O
Line Select
Serial No.
Connect
01/MH1054L1ENG/2
k Ω Hz
mAV
Lf
8k
33k
65k
User Hz
Radiodetection
Radiodetection Ltd. Radiodetection Corp.
Western Drive PO Box 623
Bristol BS14 0AZ, UK Ridgewood, NJ07451, USA
On/Off A-V-O
Line Select
Serial No.
Connect
01/MH1054L1ENG/2
8
7
RD400PDL-2/PXL-2 User Guide
FF Normal
FF Boost
Multi
Connect 24V
Connect 50V
Mode

Up

Down

Fuse
FF Normal
FF Boost
Multi
Connect 24V
Connect 50V
Mode Up
Down
Fuse
6
5
FF Normal
FF Boost
Multi
Connect 24V
Connect 50V
Mode Up
Down
Fuse
When Multi is selected, any combination of Lf, 8k,
33k and 65k can be transmitted using Direct
Connection. The selection procedure is as
follows:
Using the Mode/Select keys select Multi. A
flashing flag will appear next to Lf.
Using the Mode/Select keys select the first
frequency.
Press the Mode key. A flashing flag will appear.
Using the Mode/Select keys select the second
frequency.
Repeat as necessary to select the combination of
frequencies required.
Up (5)
Increases the output signal level. In Connect
24V/Connect 50V modes, a four level output step
chart is displayed, controlled by the Up and Down
keys. At maximum level in Connect 24V mode
pressing Up key will select Connect 50V at lowest
level on step chart.
Down (6)
Decreases the output signal level. At minimum
level in Connect 50V mode pressing Down key will
select Connect 24V at highest level on step chart.
Note: Output signal level is displayed as
percentage in Induction mode.

A-V-O (Amps-Volts-Ohms) (7)

Default mode displayed is output current (A), one
press selects and displays voltage (V), a second
press selects and displays load impedance (ý), a
third press returns to default mode.
Line (8)
Used in conjunction with A-V-O key. Press and
hold the Line key to display the line voltage, in the
V mode, and the line resistance, in the ý mode.